Blowsion Custom-cut replacement mat kit for 1993-1996 Yamaha WaveBlaster models, including side and rear pieces. This kit also includes optional rear corner pieces, designed to replace the discontinued OEM Yamaha rear corners.
Before you install: Fully remove all original equipment mats from the ski's deck surface, including any factory-installed plastic mats, before fitting your new kit.
Installation requires contact cement (sold separately); this kit is not self-adhesive
Dual Color Turf option now available
Fit and installation notes
Blowsion mat kits are built for customers ready to take on custom fitting. We manufacture our kits slightly oversized to accommodate variations in footwell locations, thicker undermatting, kick wedges, and other setup differences. In most cases, some trimming and fitting will be required for a precise fit.
Pair this kit with Surface Mat Glue, our solvent-based contact adhesive formulated specifically for mat installation.
Please Note: All Blowsion Mat Kits are custom made. Because of this shipping times will vary, please allow 2-4 days for all mat kits to be completed. All Blowsion PWC mats are sold without self-adhesive. There are no refunds or exchanges on any upholstery items.
Liability Disclaimer – Closed Course Use Only
Blowsion products are intended for closed course competition use only. These products are not designed, tested, or approved for use on public waterways or pollution-controlled vehicles.
Installation and operation of Blowsion components may affect the safety, emissions compliance, and legal status of your watercraft. Use of these products on public waterways may be a violation of federal, state, or local laws.
By purchasing and installing Blowsion products, the user assumes all responsibility and risk associated with their use, including but not limited to personal injury, property damage, or legal penalties.
Always follow proper safety procedures and consult with a qualified technician for installation.
Product Installation Disclaimer:
Warning:
When using electric or battery-operated tools inside the hull, ensure the area is well-ventilated and free of fumes. Failure to follow this precaution may result in fire, explosion, serious injury, or death.
Disconnect the battery before performing any installation or maintenance to prevent accidental ignition or electrical shock.
Allow the engine to cool completely before beginning installation.
No Smoking!
This kit is not designed for use on vehicles equipped with pollution control systems. Installing this kit on such vehicles may violate state or local laws
Please Note: Certain colors will fade, this can occur quickly and severely in some instances. Blowsion will not warranty the following colors due to fading (Lime Green, Orange, Red, Pink, Yellow and Yellow Camo).
Choosing a selection results in a full page refresh.
