Blowsion Custom Cut Mat Kit. Glue it on! Fits all 2021 and Newer Yamaha Superjet 1050cc 4-Stroke Models. Includes bottom, tray sides, dash and undermat foam. Options available with or without 2" inch rear tray corner kick wedges. Requires Contact Cement/Blowsion Mat Glue for installation. Not available with 3M Self-Adhesive.
5mm Standard Undermatting included.
Will Accommodate up to 2 inch Rear Kick Wedge.
Contact Cement Required for installation, not available with self-adhesive.
Blowsion mats are designed for the customer looking to take the next step in custom fitting. We manufacture our kits to be slightly oversized to accommodate a wide variety of installation requirements such as footwell locations, optional thicker undermatting, kick wedges, etc. In most cases trimming and fitting will be required.
Blowsion mat kits are designed to be installed directly onto the ski's deck surface. You must fully remove any and all original equipment mats, including factory-installed plastic mats (such as those commonly found on Kawasaki models), prior to installation.
Please Note: All Blowsion Mat Kits are custom made. Because of this shipping times will vary, please allow 2-4 days for all mat kits to be completed. All Blowsion PWC mats are sold without self-adhesive. There are no refunds or exchanges on any upholstery items.
Liability Disclaimer – Closed Course Use Only
Blowsion products are intended for closed course competition use only. These products are not designed, tested, or approved for use on public waterways or pollution-controlled vehicles.
Installation and operation of Blowsion components may affect the safety, emissions compliance, and legal status of your watercraft. Use of these products on public waterways may be a violation of federal, state, or local laws.
By purchasing and installing Blowsion products, the user assumes all responsibility and risk associated with their use, including but not limited to personal injury, property damage, or legal penalties.
Always follow proper safety procedures and consult with a qualified technician for installation.
Product Installation Disclaimer:
Warning:
When using electric or battery-operated tools inside the hull, ensure the area is well-ventilated and free of fumes. Failure to follow this precaution may result in fire, explosion, serious injury, or death.
Disconnect the battery before performing any installation or maintenance to prevent accidental ignition or electrical shock.
Allow the engine to cool completely before beginning installation.
No Smoking!
This kit is not designed for use on vehicles equipped with pollution control systems. Installing this kit on such vehicles may violate state or local laws
Please Note: Certain colors will fade, this can occur quickly and severely in some instances. Blowsion will not warranty the following colors due to fading (Lime Green, Orange, Red, Pink, Yellow and Yellow Camo).
Choosing a selection results in a full page refresh.
