Blowsion
Blowsion CAS Billet Aluminum One Way Valve Scupper
Blowsion CAS Billet Aluminum One Way Valve Scupper
SKU:06-01-022
Out of stock
Couldn't load pickup availability
The new CAS flow valve design prevents water getting in during tail stands, wave jumping, or all out buoy shredding. The new billet flange assembly is the premium design setup and allows use of the Blowsion Billet Exhaust Outlet so vain riders can sanitize both sides of the rear of their watercraft. The aluminum, rubber, and injection molded construction of the Blowsion one-way valve assembly along w/ the recessed internal mounting results in a bulletproof set-up. Fits all years Super Jet, KAWI 750 and SXR 800, KAWI 650, Polaris Octane, Rickter XFS, XFR, EVO, Edge and Most Aftermarket Hulls. Each pre-assembled kit includes explicitly detailed instructions, recessed one-way flow valve, special flex tubing (allows for off center mounting unlike straight PVC tube scupper systems) mounting epoxy and stainless fasteners. NOTE: Recommend Blowsion 2-Part Mixing Foam Pint Kit with install. Supersedes standard Part Number 06-01-021 and SXR only Part number 06-01-025.
Overall Length: 36" Inches
Part Number: 06-01-022
Liability Disclaimer – Closed Course Use Only
Liability Disclaimer – Closed Course Use Only
Blowsion products are intended for closed course competition use only. These products are not designed, tested, or approved for use on public waterways or pollution-controlled vehicles.
Installation and operation of Blowsion components may affect the safety, emissions compliance, and legal status of your watercraft. Use of these products on public waterways may be a violation of federal, state, or local laws.
By purchasing and installing Blowsion products, the user assumes all responsibility and risk associated with their use, including but not limited to personal injury, property damage, or legal penalties.
Always follow proper safety procedures and consult with a qualified technician for installation.
Product Installation Disclaimer:
Warning:
When using electric or battery-operated tools inside the hull, ensure the area is well-ventilated and free of fumes. Failure to follow this precaution may result in fire, explosion, serious injury, or death.
Disconnect the battery before performing any installation or maintenance to prevent accidental ignition or electrical shock.
Allow the engine to cool completely before beginning installation.
No Smoking!
This kit is not designed for use on vehicles equipped with pollution control systems. Installing this kit on such vehicles may violate state or local laws
Share
